Search service manual

General Guidance An isolation Transformer should always be used during the servicing of a receiver whose chassis is not isolated from the AC power line.

Use a transformer of adequate power rating as this protects the technician from accidents resulting in personal injury from electrical shocks. It will also protect the receiver and it's components from being damaged by accidental shorts of the circuitry that may be inadvertently introduced during the service operation.

If any fuse (or Fusible Resistor) in this TV receiver is blown, replace it with the specified.

When replacing a high wattage resistor (Oxide Metal Film Resistor, over 1W), keep the resistor 10mm away from PCB.

Keep wires away from high voltage or high temperature parts.

General Servicing Precautions
1. Always unplug the receiver AC power cord from the AC power
source before;
a. Removing or reinstalling any component, circuit board
module or any other receiver assembly.
b. Disconnecting or reconnecting any receiver electrical plug or
other electrical connection.
c. Connecting a test substitute in parallel with an electrolytic
capacitor in the receiver.
CAUTION: A wrong part substitution or incorrect polarity
installation of electrolytic capacitors may result in an
explosion hazard.

Toyota prius repair and maintenance manual 2004 2008. Therefore you are always well prepared before you even go outside and into your garage to carry out that repair for free. The Toyota Prius Hybrid service manual will show you which tools to use and how simple it will be to perform a first oil change, spark plug change, or air filter swap.You should always avoid using the wrong tool or screwdriver in a vehicle as you could end up damaging screws and nuts for good by shearing off the edges. The Toyota Prius Hybrid service manual will show you which tools and size to use.

2. Test high voltage only by measuring it with an appropriate high
voltage meter or other voltage measuring device (DVM,
FETVOM, etc) equipped with a suitable high voltage probe.
Do not test high voltage by 'drawing an arc'.

3. Do not spray chemicals on or near this receiver or any of its
assemblies.

Sign Out & In of your iCloud AccountIf the above still not working, try re-login your iCloud account from your iPhone: Settings your name Sign Out. Restart your iPhone and add it again and restart it once again.After you tried any one of the above methods, you can check whether it works t o refresh your contacts: Open the Contacts app Tap Groups in the upper-left corner Swipe down on the list to refresh your groups. Signed in to iCloud With the Same Apple IDIf you have more than one account with contacts, make sure that you’re signed in to iCloud with the same Apple ID on all of your devices. Set iCloud Contacts as defaultIf your iCloud contacts not syncing, go to Settings Contacts Default Account Select iCloud. Ford sync won't download all my contacts free. Check your iCloud account on iPhone: Tap Settings your name  Name, Phone Numbers, Email.

4. Unless specified otherwise in this service manual, clean
electrical contacts only by applying the following mixture to the
contacts with a pipe cleaner, cotton-tipped stick or comparable
non-abrasive applicator; 10% (by volume) Acetone and 90% (by
volume) isopropyl alcohol (90%-99% strength)
CAUTION: This is a flammable mixture.
Unless specified otherwise in this service manual, lubrication of
contacts in not required.

5. Do not defeat any plug/socket B+ voltage interlocks with which
receivers covered by this service manual might be equipped.

6. Do not apply AC power to this instrument and/or any of its
electrical assemblies unless all solid-state device heat sinks are
correctly installed.

7. Always connect the test receiver ground lead to the receiver
chassis ground before connecting the test receiver positive
lead.
Always remove the test receiver ground lead last.

8. Use with this receiver only the test fixtures specified in this
service manual.
CAUTION: Do not connect the test fixture ground strap to any
heat sink in this receiver.